Test Chambers

Walk-In Test Chambers

The walk-in test chamber is probably the most convenient type of testing system available. Unlike a reach-in unit, it allows the user to test multiple items of considerable size in a single environment. As part of Bruischat Environmental SieTech Engineers have designed and built walk-in chambers that range from 120 degrees below, to over 230 degrees above zero(Fahrenheit). For more click here.

Running Loss Test Chambers

A Running Loss Test Chamber is necessary for thorough Automobile emissions testing as dictated by the Environmental Protection Ageny(EPA) and the California Air Resources Board(CARB). It consists of a sealed chamber, Dynamometer, a fuel tank temperature management system, analytical equipment as well as control and testing software. For more click here.

Hot & Cold Test Chambers

Sietech’s hot & cold test chamber and soak room are an integral part of the fully equipped emissions testing facility. It was engineered to allow the user to perform specific EPA and CARB vehicle drive schedules at specified temperature and humidity conditions. It is also equipped to perform cold start-ability testing according to regulations, as well as many user defined research and development tests. For more click here.

Drive-In Test Chambers

As part of Bruischat Environmental, SieTech personnel have helped design and manufacture drive-in test chambers for automobile manufacturers around the world. These chambers can be anything from a simple hot & cold room to one that creates extreme environmental conditions such as solar, wind, rain, snow, high humidity, ultra-hot and ultra-cold. For more click here.